DMVPN Lab 7 : Phase 2 Dynamic Mapping With OSPF

 LAB 7

Seperti biasa ya kita akan melanjutkan konfigurasi ini dengan menghapus beberapa konfigurasi sebelum nya.

HUB, Spoke-1 Spoke-2

no rotuer eigrp 12

Selanjutnya konfigurasikan routing OSPF.

HUB

HUB(config)#router ospf 12 
HUB(config-router)#network 1.1.1.1 0.0.0.0 area 0 
HUB(config-router)#network 192.168.10.0 0.0.0.255 area 0 
HUB(config-router)#exit 
HUB(config)#int tunnel 0 

HUB(config-if)#ip ospf network broadcast

Spoke-1

Spoke-1(config)#router ospf 12 
Spoke-1(config-router)#network 2.2.2.2 0.0.0.0 area 0 
Spoke-1(config-router)#network 192.168.10.0 0.0.0.255 area 0 
Spoke-1(config-router)#exit Spoke-1(config)#int tun0 

Spoke-1(config-if)#ip ospf network broadcast

Spoke-2

Spoke-2(config)#router ospf 12 
Spoke-2(config-router)#network 192.168.10.0 0.0.0.255 area 0 
Spoke-2(config-router)#network 3.3.3.3 0.0.0.0 area 0 
Spoke-2(config-router)#exit Spoke-2(config)#int tun0 

Spoke-2(config-if)#ip ospf network broadcast

Selanjutnya coba lakukan ping pada di setiap router,..

HUB

HUB#ping 2.2.2.2 
Type escape sequence to abort. 
Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds: 
!!!!! 

Success rate is 100 percent (5/5), round-trip min/avg/max = 36/46/56 ms 

HUB#ping 3.3.3.3 
Type escape sequence to abort. 
Sending 5, 100-byte ICMP Echos to 3.3.3.3, timeout is 2 seconds: 
!!!!! 

Success rate is 100 percent (5/5), round-trip min/avg/max = 32/44/56 ms